Operating A Cable Box Or Dbs Receiver; Progr_G The Remote - Sony Trinitron KV-29RS26C Operating Instructions Manual

Operating a cable box or DBS receiver
Programming the remote
You can program the supplied rernote control
re) operate a cable box or DBS receiver.
1 Press CODE SET.
2 Press DBS/CABLE (FUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4 Press ENTER.
To operate the TV
Press TV (FUNCTION). Then use the TV
,control battons to control the TV.
For more details on operating the
cable box or DBS receiver
If the remote control doesn't work
• First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips "_"
• If more than one code m_mber is listed, try cnterMg
them one by one until you come to tlte correct code for
your equipment.
• If you enter a new code lll?tllber, tlle code Hltlllber you
previo_sly entered at that setting is erased.
• l_l SO!lie rare cases, IjOl? ilia!] Ilo[ be able to o_2_:rale
yo_r equipment with the supplied remote control In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries -- to replace
them, for example -- it: too ,'m_ch time is ta],e_;,the
code m_mbers may revert re,the factory setting and
must be reseL
Refer to the operating instructions that come
with the equipment.
Manufacturer code numbers
(cable box)
Manufacturer Code number
HamliniRegal 222, 2:!3, 224, 225, 226
JerroldiG. I. 201,202, 203, 204, 205, 206,
207, 208, 218
Oak 227, 228, 229
Panasonic 2[9, 220, 221
Pioneer 214, 2_ 5
Scientific Atlanta 209, 2_ 0, 211
Tocom 216, 2_. 7
Zenith 212, 2_ 3
Manufacturer code numbers
(DBS receiver)
Manufacturer Code number
Son), 801 (preset code for
re mote control)
Genera[ Electric 802
RCA/PROSCAN 802