Connecting To The Sfp Port Of The Access Point; Connecting To Sfp Port Using Cable Gland - Cisco Catalyst IW9167I Hardware Installation Manual

Connecting to the SFP Port of the Access Point

1 SFP port connected using M12 adapter
2 RJ45 port connected using M12 adapter
Connecting to the SFP Port of the Access Point
Connect to the SFP port by using a cable gland or an M12-RJ45 adapter.
Note

Connecting to SFP Port Using Cable Gland

Follow these steps to connect to the SFP port using cable gland:
Step 1
Insert the fiber SFP into the chassis.
Step 2 Disassemble the fiber adapter and slide parts over fiber cable in the order shown in the following figure:
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
42
Copper SFP or Fiber SFP will be detected by the system only after a power cycle.
3 DC power port connected using M12 adapter
Installation Overview