Power Injectors; Ethernet (Poe) Ports; Sfp Option - Cisco Catalyst IW9167I Hardware Installation Manual

Power Injectors

Power Injectors
The IW9167I Access Point supports the following power injectors:
• IW-PWRINJ-60RGDMG=: Operating: -40°C to +70°C. Power derating of 60W at 70°C, and 65W at
• AIR-PWRINJ-60RGD1=: Operation: -40°C to +50°C, 60W. Supports 10M/100M/1G rates.
• AIR-PWRINJ-60RGD2=: Operation: -40°C to +50°C, 60W. Supports 10M/100M/1G rates.
Warning
Caution

Ethernet (PoE) Ports

The AP supports an Ethernet uplink port (also for PoE-IN). The Ethernet uplink port on the AP uses an RJ-45
connector (with weatherproofing) to link the AP to the 100BASE-T, 1000BASE-T, 2.5G BASE-T, or 5G
BASE-T network. The Ethernet cable is used to send and receive Ethernet data and optionally supply inline
power from the power injector or a suitably powered switch port.
Tip
Danger
The Ethernet cable must be a shielded, outdoor rated, Category 5e (CAT 5e) or better cable. Category 6A
(CAT 6A) cable is needed for 5G rate. The AP senses the Ethernet and power signals and automatically
switches internal circuitry to match the cable connections.

SFP Option

Warning
The factory-orderable fiber option provides a fiber input and output capability. Fiber data is transmitted and
received over a single or dual-strand fiber cable, depending on the SFP, which is connected to the access point
using these SFP modules:
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
6
65°C. Supports 100M/1G/2.5G/5G/10G rates.
To reduce the risk of fire, use only No. 24 AWG or larger telecommunications line cord. Statement 1023
When the AP is installed outdoors or in a wet or damp location, the AC branch circuit powering the AP should
be provided with ground fault protection (GFCI), as required by Article 210 of the National Electrical Code
(NEC).
The AP senses the Ethernet and power signals, and automatically switch internal circuitry to match the cable
connections.
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord. Statement 1023
Class 1 laser product. Statement 1008
About Cisco Catalyst IW9167I Heavy Duty Access Point