Maintenance & Cleaning; Getting Started; Installation - Gogen ME 3397 Manual

INTRODUCTION
• Thank you for buying our product.
• Please read through these operating instructions, so you will know how to operate your
equipment properly. After you finished reading the instructions manual, put it away in a safe
place for future reference.
MAINTENANCE / CLEANING
• Ensure the unit is fully unplugged from the mains socket before cleaning.
• Never use any harsh or strong solvents to clean the device since these may damage the surface
of the device. Dry, soft cloth is appropriate, however, if the device is extremely dirty, it may be
wiped off with a slightly moist cloth. Make sure the device is dried off after cleaning.
DISPLAY
NOTE: You can find the picture of the display at the beginning of the user manual.
1. Weather forecast, Atmospheric pressure and its trend, Moon phase
2. Time, Date, Day, Alarm
3. Indoor temperature/humidity, Max/Min record of temperature/humidity
4. Sensor 1 > Outdoor temperature/humidity and their trend, Max/Min, Battery status
5. Sensor 2 > Outdoor temperature/humidity and their trend, Max/Min, Battery status
6. Sensor 3 > Outdoor temperature/humidity and their trend, Max/Min, Battery status

GETTING STARTED

Installation

The main unit and the outdoor sensor can be placed onto any flat surface, or wall mounted by the
hanging hole at the backside.
NOTE: Transmissions between the main unit and the outdoor sensor can reach up to 70 m in an open area. Open
area means there are no interfering obstacles such as buildings, walls, trees, high voltage lines, etc.
Outdoor Sensor
NOTE: Batteries compartment is located behind the back cover.
• Insert 2 x AA batteries [not included] observing polarity ["+" and "–" marks].
• Set the Channel number [1/2/3] of the sensor and the Temperature units [°C/°F].
The display shows the set Channel number, temperature, and humidity.
Main Unit
• Connect the power adaptor to the DC IN socket, which is located
in the batteries compartment, then plug it into the power socket.
NOTE: Make sure your local voltage is the same as marked on the adaptor.
The display backlight is on. To adjust the brightness (High, Low, off), press the
SNOOZE/LIGHT button.
• Insert 3 x AA batteries [not included] observing polarity ["+" and "–" marks].
The display backlight is off. To turn on the display, press the SNOOZE/LIGHT button and the display will light up for
about 20 seconds.
EN