Operation; Dmx-512 Connection / Connection Between Fixtures - EuroLite PAR-64 RGB DMX Color Changer User Manual

The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Color changers must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the PAR-64 RGB DMX color changer starts running. The
ventilation fan begins to rotate and the display lights up.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
International
L
N
the fixtures will not work at all, or will not work properly.
21/48 00018983.DOC, Version 1.0