Table of Contents
Advertisement
Note: if the security state is mixed, then disable security for those PMEMs in System Setup by
selecting the scope of "Single PMEM" under the (System Settings > Intel Optane PMEMs >
Security) firstly before take the action to provision the passphrase. If PMEMs are not unlocked,
system will not see or access the persistent region of PMEMs.
• FQXSFMA0039K: One or more Intel Optane PMEMs could not be auto unlocked because of invalid
passphrase.
Severity: Warning
User Action:
Complete the following steps:
1. Use OneCLI to check which PMEM is failed for unlock. Using different passphrases could caused
auto unlock failure.
2. Use UEFI setup page or Intel PMEM OS tool to unlock the related PMEM with right passphrase.
3. in order to avoid this auto unlock failure in next boot, change the passphrase of these PMEMs in
System Setup utility with the scope of "Single PMEM" under the (System Settings > Intel Optane
PMEMs > Security).
Note: If PMEMs are not unlocked, system will not see or access the persistent region of PMEMs.
4. If the issue is not resolved then contact Lenovo Support.
• FQXSFMA0040K: Invalid Intel Optane PMEM configuration detected. Please verify PMEM
configuration is valid.
Severity: Warning
User Action:
Complete the following steps:
1. Check system spec and follow the rules for populating PMEM in correct order.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0041K: Near Memory/Far Memory ratio (1:[arg1].[arg2]) for Intel Optane PMEM
configuration is not in recommended range (1:[arg3] - 1:[arg4]).
Severity: Warning
Parameters:
[arg1]: The integer part of Far Memory/Near Memory ratio [arg2]: The decimal part of Far Memory/Near
Memory ratio [arg3]: Lower limit of Far Memory/Near Memory ratio [arg4]: Upper limit of Far Memory/Near
Memory ratio
User Action:
Complete the following steps:
1. Validate system's memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
2. Resolve DIMM configuration so that the PMEM ratio meets firmware requirements, then reboot the
system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0042K: Intel Optane PMEM is not supported by processor of this system.
Severity: Error
User Action:
.
171
Chapter 3
UEFI events
Advertisement
Table of Contents
