Table of Contents
Advertisement
• Lineup openings, i nsertclevispinthrough
assembly andsecurewithcotterpin.
Spread endsofcotterpinto lockin place.
Seefigurebelow.
__/
Universaljoint
Upper Crank Rod
• Tighten nut on eye bolt, keeping eye in
line with the rod while tightening the in-
side securely.
• Tighten screw in right hand upper hole.
TO INSTALL SHIFTER LEVER KNOB
• Thread the hex nut found in the parts bag
onto shifter lever. Thread the shifter lever
knob onto the threaded end of the shifter
lever until it is snug against the hex nut
and the lip is pointed away from the en-
gine. "Rghten hex nut against the bottom
of the shifter lever knob. See figure below.
Hex Nut
ShifterLever
TO ASSEMBLE
SNOW CHUTE
• Tum crank assembly counterclockwise
until it stops.
• Locate three carriage bolts, flatwashers
and nuts (found in parts bag) from snow
chute flange. DO NOT remove carriage
bolt over worm gear.
• Position snow chute on snow chute flange
and align the three holes in the snow
chute with holes in the snow chute flange
as shown in figure below.
• Install carriage bolts from inside of chute
as shown in figure below, flatwashers
and
nuts.
• "13ghtencarriage bolts securely. Be careful
not to overt'_hten. See figure below.
•Tum
crank assembly clockwise and make
sure all carriage bolts are tight.
Locknut
.Snow Chute
Snow Chute Range
e Bolts
TO CHECWADJUSTCLUTCH
CONTROLCABLES
NOTE:
If the cables have become discon-
The control cables attachedto
the auger
nected, reinstall spring as shown in figure
clutch lever and traction clutch lever as
below,
shown in figure below may need to be ad-
4" Lg free state
justed before you use your snow thrower.
\
3" Lg free state n Auger drive
For instructions on checking or adjusting
Traction
_
'_
_ spnng
the control cables, (See To Adjust Clutch
ddve _._._4
._-_
_'_
/,
Control Cables paragraph on page17),
spdng.
I
Tractic_n dr'we
Auger ddve
.........
N
\Co
t os
n
Advertisement
Table of Contents
