Table of Contents
Advertisement
HOW TO USE THE MAINTENANCE SECTION
1. Select the settings main menu.
See step 1 on page 25.
2. Select the maintenance section.
In the settings main menu, scroll to the
Maintenance section.
3. Update the console firmware.
For the best results, regularly check for
firmware updates.
Touch the Update button to check for firmware
updates using your wireless network. The update
will begin automatically.
To avoid damaging the treadmill, do not turn off
the power or remove the key while the firmware
is being updated.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position, wait for several
seconds, and then press the power switch into the
reset position. Note: It may take a few minutes for
the console to be ready for use.
Note: Occasionally, a firmware update may cause
the console to function slightly differently. These
updates are always designed to improve your exer-
cise experience.
4. Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. Then, touch the
Begin button to calibrate the incline system. The
treadmill will automatically rise to the maximum
incline level, lower to the minimum incline level,
and then return to the starting position. This will
calibrate the incline system. Touch the Cancel
button to return to the maintenance section. When
the incline system is calibrated, touch the Finish
button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline sys-
tem is calibrating. In an emergency, pull the key
from the console to stop the incline calibration.
5. Exit the maintenance section.
To exit the maintenance section, touch the back
button on the screen.
HOW TO USE THE BLUETOOTH SPEAKERS
1. Place or hold your BLUETOOTH-enabled device
near the console.
2. Turn on your device's BLUETOOTH setting.
3. Pair your device to the console.
Press and hold the BLUETOOTH button on
the console's speaker grill for 3 seconds. The
BLUETOOTH speakers will enter pairing mode.
When your device and the console pair success-
fully, the audio from your device will play through
the console's speakers.
Note: The console can save 8 devices in its mem-
ory. If you have previously paired your device to the
console, you can simply press the BLUETOOTH
button to connect your device to the console.
4. Erase the console's device memory if
necessary.
If you need to erase all the BLUETOOTH-enabled
devices saved in the console's memory, press and
hold the BLUETOOTH button for 10 seconds.
26
Advertisement
Table of Contents
