Replacing The Battery Pack; Removing The Battery Pack - Toshiba Qosmio F10-124 User Manual

Replacing the battery pack

When the battery pack reaches the end of its operating life you will need to
install a new one. The life of the battery pack is generally about 500
recharges. If the Battery indicator flashes orange shortly after fully
recharging the battery, the battery pack needs to be replaced.
You might also replace a discharged battery pack with a charged spare
when you are operating your computer away from an AC power source.
This section explains how to remove and install the battery pack.

Removing the battery pack

To replace a discharged battery, follow the steps below.
I
When handling battery packs, do not short-circuit the terminals. Also do
not drop, hit or otherwise apply impact; do not scratch or break the
casing and do not twist or bend the battery pack.
I
Do not remove the battery pack while the computer is in Standby mode.
Data is stored in RAM, so if the computer loses power it will be lost.
I
In Hibernation mode, data will be lost if you remove the battery or
disconnect the AC adaptor before the save is completed. Wait for the
Disk indicator to go out.
I
Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
1. Save your work.
2. Turn the computer's power off. Make sure the Power indicator is off.
3. Remove all cables connected to the computer.
4. Turn the computer upside down.
5. Slide the battery safety lock towards the release (
the battery release latch movable.
6. Slide the battery release latch to free the battery pack for removal, then
slide out the battery pack.
User's Manual
Battery pack
Releasing the battery pack
Power
) position to make
Battery
release latch
Battery
safety lock
6-11