How To Start A Warm Engine; Frozen Start - Craftsman 536.8818 Operator's Manual

8 horsepower electric start dual stage
Table of Contents

Advertisement

Available languages

Available languages

[o_o)_l
felt and then pull rapidly
to start the
engine.
Do not allow the recoil
starter
handle
to snap back. Slowly
return
the recoil
starter
handle.
9.
If the engine
does not start in 5 or 6
tries, See Difficult
Starting
in the
"Troubleshooting
Table".
10. Allow the engine
to warm
up for
several
minutes.
As the engine
warms
up, adjust the choke
knob
toward
the RUN position.
Wait until
the engine
runs smoothly
before
each choke
adjustment.
11. (Electric
Start)
First disconnect
power
cord from receptacle.
Then,
disconnect
the power
cord from the
starter
motor.
How To Start A Warm
Engine
If restarting a warm engine after a short
shutdown, leave the choke lever in the
off position and do not push the primer
button.
If the engine fails to start, follow
the Cold Start instructions.
Frozen Starter
If the starter
is frozen
and will not turn
the engine,
follow
the steps below.
1.
Pull as much starter
rope as pos-
sible out of the starter.
2.
Release
the starter
handle
and let it
snap back against
the starter.
Re-
peat until the engine
starts.
Warm
engines
will cause condensation
in cold weather.
To prevent
possible
freeze-up
of recoil starter
and engine
controls,
proceed
as follows
after each
snow
removal
job.
1.
With engine
off, allow engine
to cool
for several
minutes.
2.
Pull starter
rope very slowly
until re-
sistance
is felt, then stop. Allow
the
starter
rope to recoil.
Repeat
three
times.
3.
With the engine
not running,
wipe all
snow
and moisture
from the carbu-
retor cover
in area of controls
and
levers.
Also,
move the choke
control
and starter
handle
several
times.
,_
WARNING: Never run en-
gine indoors or in enclosed,
poorly ventilated areas.
En-
gine exhaust contains CARBON
MONOXIDE, AN ODORLESS AND
DEADLY GAS. Keep hands, feet,
hair and loose clothing away from
any moving parts on engine and
snow thrower.
Engine parts, especially the muf-
fler, become extremely hot. Se-
vere thermal burns can occur on
contact. Allow the engine to cool
before touching.
Never allow children to operate
the snow thrower. Never allow
adults to operate the snow throw-
er without proper instruction.
Keep the area of operation clear
of all persons, particularly small
children and pets.
Never leave the enowthrower un-
attended while the engine is run-
ning. Anyone operating the en-
gine or equipment
must carefully
read and understand the operat-
ing instructions.
F 0410108L
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

536.881800

Table of Contents