Cleaning Modes - Shark Navigator Lift-Away ZU503AMZ Owner's Manual

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Off
I Hard Floor
For bare floors and area rugs
II Carpet
For high pile carpets
NOTE: The brushroll spins in both modes.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn off the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
The Suction Control Slider located on the
handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT MODE
To engage Brushroll, step on floor nozzle and
tilt handle back firmly. Press the Power/Surface
switch to the appropriate floor setting.
ABOVE-FLOOR—HANDLE
Press the Handle Release button and pull up
on the handle to detach it from the wand.
In Lift-Away mode, you can clean with the handle and wand or just the handle.
LIFT-AWAY® LIFT-AWAY WAND
Press the Lift-Away button to
With pod removed, press the
detach the pod from the floor
Wand Release button to detach
nozzle.
the wand from the pod.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button and pull up
on the wand to detach it from the pod.
LIFT-AWAY HANDLE
Press the Handle Release button
and pull up on the handle to
detach it from the wand.
s h a r kc l e a n . c o m