Table of Contents
Advertisement
en Water softening system/special salt
Adjusting the water softening
system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not required
at the set value 0-8.
Set the softening system as follows:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Open the door.
3.
Switch on ON/OFF switch (.
4.
Press Info button { 8 for 3
5.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > )R until the
6.
water hardness is indicated on the
display window at the top @.
Make the setting with setting buttons
7.
+ - `.
Press and hold the Info button {
8.
8 for 3 seconds.
The chosen setting has now been
stored.
20
Using special salt
As soon as the low salt indicator P is
lit on the control panel or is requested
on the front display * ):, salt should
be topped up. Always refill with special
salt immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode
the rinsing tank.
Caution!
Detergent will destroy the water
softening system! Never pour detergent
into the salt dispenser.
Top up the salt as follows:
Undo the screw plug on the
1.
dispenser 1b.
Fill the dispenser with water
2.
(required only when switching on the
appliance for the first time).
Add salt as illustrated (do not use
3.
table salt or tablets).
The water is displaced and runs out.
* depending on the features of your
dishwasher
Advertisement
Table of Contents
