Table of Contents
Advertisement
en Getting to know your appliance
Initial start-up
When the dishwasher is switched on for
the first time, you are taken directly to
the settings for the initial start-up.
If you select Home Connect
Note:
during the initial start-up, make further
settings via your dishwasher App.
Observe the supplied Home Connect
documents.
On the display window at the top @
the following text appears for manual
selection:
Initial start-up settings
Sprache/Language
Home Connect
Time format
Time setting
Water hardness
Rinse aid disp.
Water connection *
* depending on the features of your dishwasher
--------
12
Factory setting
Deutsch
Manual/Home Connect
24 h
12:00
°E 16 - 20 medium
Level 5
Cold water
Scroll with < >
Set with - +
Leave with Setup 3 sec.
The required settings for the initial
start-up are listed in the table below.
To change the setting:
Keep pressing button >)R until the
1.
required setting is displayed.
Change the setting with setting
buttons + -`.
Press and hold the Info button {
2.
8 for 3 seconds.
The chosen setting has now been
stored.
Infotext
by pressing Info button {
Language selection.
Manual/Home Connect.
12h or 24h.
Set the current time.
Adjustment to the local water hardness.
When using Multitabs, select setting 0 - 6.
Amount of rinse aid affects drying. When
using Multitabs, select setting 0.
Connection to hot water (40-60°C) or cold
water (<40°C) possible.
Advertisement
Table of Contents
