SATO M-8485Se Service Manual page 146

Replacing the Label Gap Sensor Board (Bottom 1/2) and "Eye-Mark"
Sensor (Reflective) Board
Fig. 6-50
REMOVE (2) SCREWS,
"EYE-MARK
SENSOR
LABEL GAP
SENSOR
(BOTTOM 1/2)
PN 9001080
Rev. A
(2) SPACERS AND
PLASTIC SHIELD
OPEN BUNDLE TIE
Figs. 6-52
SATO M-8485Se Standard Print Engine
Fig. 6-51
SEN1 CABLE
SENSOR HARNESS @ (CN8)
CONNECTOR FOR SEN1, & SEN2
Service Manual
Section 6. Replacement Procedures
UNSNAP CABLE
HOLDER
CONNECTOR FROM LABEL
GAP SENSOR BOARD INTO
SENSOR HARNESS
MARKED "SEN1"
Fig. 6-53
Page 6-33