Abus PPIC91000 Operating Instructions Manual page 26

4. If you have not already done so, first connect the base station to the router via the network cable.
Then connect the base station to the power supply. The base station is ready as soon as the red
power LED lights up. Click on "Search camera in network" to continue with the installation.
5. Select your base station using the identification number. You will find the identification number
(DID) enclosed in the packaging. Alternatively, this can be found on the underside of the base
station.
6. Attach the camera antenna (if you have not already done so) and switch on the camera by pressing
and holding the On/Off button on the back of the camera for 3 seconds. This causes the status LED
on the back of the camera to flash (red). Confirm in the app with "Next".
7. Assign a name for the base station. This name will be displayed later in the camera overview. For
push notifications, you must also enter the name in the camera settings after start-up. The name
can be changed later on at any time.
8. Now assign a security code and an admin password. Then tap on "Next".
9. For the best possible camera experience, we recommend that you always operate the base station
and cameras with the latest firmware. Confirm the message with "OK".
26
English