Installing The Rollotron Basic 1100 - RADEMACHER RolloTron Basis 1100 Translation Of The Original Operating And Assembly Manual

i

11. Installing the RolloTron Basic 1100

Mount the RolloTron Basic 1100 as straight as possible,
so that the belt can wind correctly.
Ensure that the RolloTron Basic 1100 sits freely in the
belt box and that it is not in contact with the masonry,
otherwise this may cause noise during operation.
1.
Slide the RolloTron Basic 1100 into the belt box and screw
it tight using the screws provided.
A damaged connecting cable may cause a short
circuit.
Ensure that the connecting cable is laid correctly inside
the cable duct, otherwise it can be crushed and damaged
when the cover is screwed in place.
2.
Re-insert the mains plug into the 230 V / 50 Hz socket.
Leave the bottom cover plate open until all
i
settings have been carried out.
WARNING!
EN
67