RADEMACHER RolloTron Basis 1100 Translation Of The Original Operating And Assembly Manual page 79

i
19. What to do if... ?
Fault
... the roller shutters stop during downward travel?
... the indicator light flashes and the RolloTron Basic
1100 fails to operate in either direction?
... the RolloTron Basic 1100 fails to react properly
either manually or automatically?
Possible cause / solution
a) The roller shutters may have hit an obstacle.
Move the roller shutters back up and remove the obstacle.
b) Slats have shifted out of alignment.
If possible, move the roller shutters back up and realign the slats.
c) The roller shutters scrape against the window frame inside the
roller shutter box due to the lack of a pinch roller or insulation
material may have come free and is jamming the roller shutters.
Open the roller shutter box and rectify the fault.
Lubricate any stiff areas with gliding wax if necessary.
d) The roller shutters are too light.
Increase the weight of the roller shutters by, for example, adding
a piece of flat steel to the bottom slat.
The maximum running time of the drive has been exceeded, see
page 48/57.
The motor is too hot. The belt winder will be fully operational
again in approx. 1 hour.
The RolloTron Basic 1100 is no longer operational. Carry out a software
reset in accordance with the instructions on page 74 and test the
RolloTron Basic 1100 using the default factory settings.
EN
79