Servicing Recommendations; Lubricating Controls - Ikelite 71301 Instructions Manual

2. Remove the rear and front o-rings. Place in a small re-sealable
plastic bag inside of the housing.
3. Leave the lid snaps open to release pressure on the lid snap
springs.
4. Disassemble and thoroughly rinse the base with quick release
handle(s) and hardware prior to storage.
5. Store the housing in a cool, dry place away from direct sunlight
and chemicals.
6. Before using the housing, check the tightness of the set screw in
each control knob. Check each control gland to make sure they are
snug. There is a slight chance that either could vibrate loose during
travel.
Do not leave the camera and housing in direct sunlight for
»
prolonged periods. Heat may damage the camera.
Do not transport with the camera inside of the housing.
»
Do not store the housing in a humid environment. Prolonged
»
exposure to high humidity may damage electronic
components.

Servicing Recommendations

It is recommended that the housing be sent to Ikelite or an authorized
service center annually for routine service and maintenance. Service
may be required more or less frequently depending on care and use.

Lubricating Controls

The housing's controls may need to be lubricated if they become
difficult to use or if the o-rings have dried out during longer periods of
storage.
Use only Ikelite lubricant. Other types of lubricant may cause
»
swelling of o-rings or cracking of plastic components.
26