Pump Servicing Instructions 13 - Polygroup SUMMER WAVES SKIMMERPLUS SFX1000 Owner's Manual

The most efficient way to troubleshoot or replace the Pump is to disassemble the entire filtration system. Please drain the water level to below the pool's Skimmer
Opening, then disassemble the system following the steps below.
CAUTION:
1. You may get wet.
2. Please read and follow the instructions carefully. Incorrect handling may cause damages resulting in leaks between the Skimmer Canister
3. REMEMBER TO KEEP ALL THE PARTS IN A SAFE PLACE FOR REASSEMBLY LATER.
STEP 1: Removal of Motor Assembly 3
1. Turn the Pump off, and unplug it from the power outlet.
2. Slide open the Skimmer Top Cover
3. At the Return Fitting :
o
a. Unscrew and remove the RF Locking Ring and RF Diverter. Then insert the Service Plug to block the water flow.
b. Loosen the Hose Clamp attaching to the 90° Elbow
NOTE: you may also detach the other end of Hose attaching to the Canister, but it is not required.
4. Unscrew the Skimmer Seal Ring
5. Flip the Canister upside down. Unscrew the Motor Seal Nut
IF YOU PREFER TO LEAVE THE SYSTEM ATTACHED TO THE POOL, please follow the process
below instead.
CAUTION:
you will need two people for some of the steps. Incorrect handling may cause damages resulting in leaks between the Skimmer Canister
the pool wall.
1. Turn the Pump off, then unplug it from the power outlet.
2. Block the water flow:
a. Unscrew and remove the RF Locking Ring
Then insert the Service Plug
s
b. Push the Water Stopper tightly into the Skimmer Seal Ring
f
PUMP SERVICING INSTRUCTIONS PUMP SERVICING INSTRUCTIONS
, remove the Strainer Basket and the Filter Cartridge.
5
. Carefully detach the Hose, and let the water drain from the Hose and the Canister.
r
to remove the entire filtration system from the pool.
d
and take out the Motor Assembly.
1
and RF Diverter
a p
to block the water flow.
d
3. Put a water container (not included) under the Skimmer to collect water.
Slide open the Top Cover
. Filter Cartridge
7
4. Have one person holding the Water Stopper and Skimmer Canister
. while the other person unscrews the Motor Seal Nut
CAUTION: DO NOT PUSH OR PULL THE CANISTER as this may cause
damage between the Canister and pool liner.
OWNER'S MANUAL
9
, and take out the Strainer Basket
5
.
1
9
1
and the pool wall.
and
9
and
g
,
9
.
13