1. Manuals
  2. Brands
  3. SafeWaze Manuals
  4. Safety Equipment
  5. FS-EX213
  6. Operation and instruction manual

SafeWaze FS-EX213 Operation And Instruction Manual

Hybrid swivel anchor
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
OPERATION AND INSTRUCTION MANUAL
Hybrid Swivel Anchor Model: FS-EX213
WARNING:
ALL PERSONS USING THIS EQUIPMENT MUST
READ AND UNDERSTAND ALL INSTRUCTIONS. FAILURE TO DO
SO MAY RESULT IN SERIOUS INJURY OR DEATH. USERS SHOULD
BE FAMILIAR WITH PERTINENT REGULATIONS GOVERNING THIS
EQUIPMENT. ALL INDIVIDUALS WHO USE THIS PRODUCT MUST
BE PROPERLY INSTRUCTED ON HOW TO USE THE DEVICE. AVOID
CONTACT WITH PHYSICAL HAZARDS (THERMAL, CHEMICAL,
ELECTRICAL, ETC.). MAKE ONLY COMPATIBLE CONNECTIONS.
Patent # US 8,424,638 B1
V3.1-A

Advertisement

Table of Contents
loading

Related Manuals for SafeWaze FS-EX213

Summary of Contents for SafeWaze FS-EX213

  • Page 1 OPERATION AND INSTRUCTION MANUAL Hybrid Swivel Anchor Model: FS-EX213 WARNING: ALL PERSONS USING THIS EQUIPMENT MUST READ AND UNDERSTAND ALL INSTRUCTIONS. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY OR DEATH. USERS SHOULD BE FAMILIAR WITH PERTINENT REGULATIONS GOVERNING THIS EQUIPMENT.

  • Page 2: Use Instructions

    PURPOSE The FS-EX213 is an anchorage connector designed to function as an interface between the anchorage and a fall protection, work positioning, rope access, or rescue system for the purpose of coupling the system to the anchorage. Any references to “anchorage connector”...

  • Page 3: Component Materials

    Tensile Strength (UTS): 10,000-lbf (44kN) Maximum Capacity: See “Use Limitations” Weight: 2.0-lbs (949g) Regulatory Compliance ANSI Z359.18 Type T, ANSI Z359.7-2011 OSHA 1910.66 , OSHA 1926.502 6.25” (15.88cm) 2.25”ø (57.15mm) 5.5” Compression Sleeve (139.7mm) Bushing Bolt Cone Cable Spoon 3” 1”...
  • Page 4 180˚ 8.0”ø (203.2mm) 360˚ LOADING CONDITIONS DIAGRAM LOAD LOAD LOAD LOAD ACCEPTABLE ACCEPTABLE ACCEPTABLE IMPROPER DRILLING : 1. Use a hammer drill (SDS), drill a 1” (2.54 cm) diameter hole at least 5” (12.7 cm) deep. The drilled hole must be straight and perpendicular to the surface.

  • Page 5: Installation

    Check for kinked or frayed cables. Look for signs of wear on spoons. Swivel should move freely. INSPECT BEFORE USE Check for deformation of cone. INSTALLATION: 2. Pull up on bolt while holding swivel 1. Before installing make sure cone is flush with the concrete.
  • Page 6 REMOVAL: 1. Loosen bolt so that at least .75” (1.9cm) of threads are exposed. Unscrew min of .75”(1.9cm) .75” (1.9cm) Step 1. 2. Use a hammer to tap down bolt and disengage cone from spoons. 3. Pull anchor from hole. Step 2.
  • Page 7 (ANCHOR POINT) WORK SURFACE *The structure the anchorage is attached to must be able to *The user shall be equipped with a means of support 10,000-lbf limiting the maximum dynamic forces exerted (44kN) and installed on the user during the arrest of a fall to a under the supervision maximum of 8 kN (1800-lbf ).

  • Page 8: Maintenance, Cleaning And Storage

    LIMITED REMEDY: Upon notice in writing, SafeWaze will repair or replace all defective items at SafeWaze’s sole discretion. SafeWaze reserves the right to require that the defective item be returned to its plant for inspection before determining the appropriate course action. Warranty does not cover equipment damage resulting from wear, abuse, damage in transit, failure to maintain the product or other damage beyond the control of SafeWaze.

Table of Contents