Table of Contents
Advertisement
Quick Links
Part
Number
019-2008
019-2022
020-2051
020-2052
020-2053
021-2074
022-2080
022-2081
FS813
FS813-24
FS813-2D
FS813-LOOP 18" D-Ring Extender: So� Loop, D-ring
FS814
WARNING
This product is part of a personal fall arrest, work positioning, or rescue system. The manufacturer's
instructions must be provided to users of this equipment. The user must follow the manufacturer's instructions
for each component of the system. The user must read and understand these instructions before using this
equipment. Manufacturer's instructions must be followed for proper use and maintenance of this equipment.
Alterations to this product, misuse of this product, or failure to follow instructions may result in serious injury or
death.
IMPORTANT
Questions regarding the use, care, or suitability of this equipment for your application? Contact Safewaze.
IMPORTANT
Record identification information before using this product. Identification information may be found on the
equipment label (See Figure 10). This information should be recorded in the "Inspection Form" located at the
back of this manual (p 14).
220-00029
Descrip�on
18" D-ring Extender: So� Loop, 2 D-rings
12" D-Ring Extender w/ So� Loop
18" D-Ring Extender, Orange
18" Dual D-Ring Extender, D-RING & 2 Snap Hooks Z359.11-2021
18" D-Ring Extender, Loop, Aluminum D-ring
18" D-ring Extender: Alu Rebar Hook, D-ring
12" Arc Flash D-Ring Extender w/ So� Loop
18" Arc Flash D-Ring Extender: So� Loop, D-ring
18" D-Ring Extender: Snap Hook, D-ring
24" D-Ring Extender, Snap Hook
18" D-Ring Extender: Snap Hook, 2 D-rings
18" D-ring Extender: Rebar Hook, D-ring
OSHA 1910.66, OSHA 1926.502
This manual is intended to meet the manufacturer's instructions as
required by ANSI Z359.11 and should be used as part
of an employee training program as required by OSHA.
ANSI Standard
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
Z359.11-2021
ANSI Z359.11-2021
D-ring Extender
Manual
OSHA Regula�on
Weight Capacity
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
1926.502
ANSI 130-310 lbs., OSHA up to 420 lbs.
1910.140
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SafeWaze 019-2008
Summary of Contents for SafeWaze 019-2008
- Page 1 Alterations to this product, misuse of this product, or failure to follow instructions may result in serious injury or death. IMPORTANT Questions regarding the use, care, or suitability of this equipment for your application? Contact Safewaze. IMPORTANT Record identification information before using this product. Identification information may be found on the equipment label (See Figure 10).
-
Page 2: Table Of Contents
12.0 PRE-USE INSPECTION ..........10 13.0 USE ................. 10 14.0 MAINTENANCE, CLEANING & STORAGE ....10-11 15.0 INSPECTION ...............11-12 16.0 LABELING ............... 13 17.0 INSPECTION FORM ............14 User Information Date of First Use:______________________________ Serial#:____________________________________ Trainer:____________________________________ User:______________________________________ V1.0 2022 Copyright Safewaze... - Page 3 Leading Edge Rated SRL or Energy Absorbing Lanyard. Use of a Safewaze D-ring Extender in any Leading Edge application may result in serious injury or death! NEVER attach addtional equipment to the Dorsal D-ring of a Full Body Harness while a D-ring extender remains connected.
- Page 4 Correct fit of a Full Body Harness (FBH) is essential to proper performance. Users must be trained to select the size and maintain fit of the FBH selected for use with the Safewaze D-ring Extender. Users must follow manufacturer’s instructions for proper fit and sizing, paying particular attention to ensure that buckles are connected and aligned correctly, leg straps and shoulder straps are kept snug at all times, chest straps are located in the middle chest area and leg straps are positioned and snug to avoid contact with the genitalia should a fall occur.
- Page 5 F- Waist, Rear Attachment Application Harness Attachment Location Fall Arrest Dorsal, Sternal, Frontal Restraint Dorsal, Sternal, Frontal, Hip, Rear Work Positioning Frontal, Hip Rescue Dorsal, Sternal, Frontal, Shoulder Controlled Descent Dorsal, Sternal, Frontal Climbing Dorsal, Sternal V1.0 2022 Copyright Safewaze...
- Page 6 2. Equipment which is in need of, or scheduled for, maintenance shall be tagged as unusable and removed from service. 3. Equipment shall be stored in a manner as to preclude damage from environmental factors such as temperature, light, UV, excessive moisture, oil, chemicals and their vapors or other degrading elements. V1.0 2022 Copyright Safewaze...
-
Page 7: Introduction
1.0 INTRODUCTION Thank you for purchasing a Safewaze D-ring Extender. This manual must be read and understood in its entirety, and used as part of an employee training program as required by OSHA or any applicable state agency. This manual and any other instructional material must be available to the user of the equipment. -
Page 8: Limitations & Requirements
6.0 LIMITATIONS & REQUIREMENTS When installing or using this equipment always refer to the following requirements and limitations: 6.1 CAPACITY Safewaze D-ring Extenders are designed for the following weight capacities (Maximum capacities include clothing, tools, and equipment): ANSI Z359: 130-310 lbs max... - Page 9 Greater clearance is needed to ensure safety during a swing fall as vertical fall distance will be greater than a fall originating directly below the anchorage point. FIGURE 3 - SWING FALLS FALL-ARREST V1.0 2022 Copyright Safewaze...
-
Page 10: Compatibility Of Components
Non-compatible connectors may unintentionally disengage (See Figure 4). Connectors must be compatible with the anchorage or other system components (See Figure 5). Connectors must be compatible in size, shape, and strength. Self-locking snap hooks and carabiners are required by ANSI Z359 and OSHA guidelines. Contact Safewaze if you have any questions about compatibility. -
Page 11: Application Limits
Heavyweight: Although ANSI Z359.11 specifies a weight capacity range of 130 to 310 lbs. (59 to 140 kg), most Safewaze D-ring Extenders have a maximum weight capacity of up to 420 lbs. (191 kg). If the user has a weight that exceeds the ANSI max weight of 310 lbs. -
Page 12: Pre-Use Inspection
13.2 AFTER A FALL Should the Safewaze D-ring Extender be exposed to an the force of a fall, or shows damage consistent with the effects of a fall, it must be IMMEDIATELY removed from service. Equipment must then be disposed of (See Section 15.5). -
Page 13: Inspection
Hang the extender and allow to fully dry before using. Do not dry the extender in a commercial type dryer, or use heated air to dry. 14.3 STORAGE Store Safewaze D-ring Extenders in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect extender after any period of extended storage. - Page 14 15.4 PRODUCT LIFE The working life of Safewaze D-ring Extenders are determined by work conditions, care and inspection provided. As long as the extender passes inspection, it may remain in service. 15.5 DISPOSAL Dispose of the Safewaze D-ring Extender if it has experienced fall arrest forces or inspection reveals an unsafe or defective condition.
-
Page 15: Labeling
16.0 LABELING FIGURE 10 - LABEL EXAMPLES V1.0 2022 Copyright Safewaze... -
Page 16: Inspection Form
Heat / UV Damage PASS FAIL NOTE STITCHING Impact Indicators Shoulder / Chest / Leg / Back Straps NOTES 225 Wilshire Avenue SW, Concord NC 28025 • 800-230-0319 • www.safewaze.com If equipment fails inspection IMMEDIATELY REMOVE FROM SERVICE V1.0 2022 Copyright Safewaze... - Page 17 Safewaze 225 Wilshire Ave SW Concord, NC 28025 PHONE: 1-800-230-0319 FAX: 1-704-262-9051 WEB: Safewaze.com EMAIL: info@Safewaze.com V1.0 2022 Copyright Safewaze...
Need help?
Do you have a question about the 019-2008 and is the answer not in the manual?
Questions and answers