Technical Data - Jonsered HT24i Operator's Manual

LED screen
LED 1 is red and LED 2 is
green, battery pack does not
charge or operate correctly in
product
RED LED comes on, LED 2
is green and flashes during
charging or when the battery
pack is in the battery charger
RED LED flashes and LED 2
flashes green when the bat-
tery pack is installed.
Motor specifications
Motor type
Motor voltage
Motor power
Battery and charger specifications
Default battery pack type
Default battery charger type
Blade specifications
Blade speed (standard / boost)
Blade length
Cutting capacity
Product dimensions
Weight (without battery)
315 - 002 -
Possible faults Possible steps
Battery pack failure Remove battery pack from the product. Do not charge. Battery
pack is damaged and must be replaced. Speak to an approved
service center.
Internal battery Move the battery charger and battery pack to a location where
tempature is too the internal temperature of the battery pack can be between
low or too high for 5°C (41°F) and 45°C (113°F).
charging
Internal battery The internal temperature in the battery must be between -15°C
temperature is too (5°F) and 70°C (158°F). The environment temperature in the
low or too high battery pack is too low or too high.
•
•

TECHNICAL DATA

unit
V (DC)
W
min
cm (in)
mm (in)
kg (lb)
If the battery pack is too cold from the ambient environ-
ment, move the battery pack and battery charger to a warm
environment.
If the battery pack is too hot, especially after operation,
move the battery pack and battery charger away from the
hot environment.
HT24i (BHT58VJN)
Brushless
58
400
140Li
440Ci
1
1400 / 1900
60 (23.6)
19 (0.75)
3.66 (8.1)
9