Page 1
J O N S E R E D S E R V I C E Owner's manual Read these instructions carefully and make sure you under-stand them before using the machine. Bedienungsanleitung Lesen Sie die Bedienungsanweisung sorgfältig durch und machen Sie sich mit dem Inhalt vertraut, bevor Sie die Maschine benutzen.
Key to symbols WARNING! Switch off the engine by moving the Hedge trimmers can be danger- stop switch to the STOP position ous! before carrying out any checks or Negligence or incorrect use can maintenance. result in serious, even fatal injury.
Contents Husqvarna AB has a policy of continuous Symbols explanation product development and therefore Symbols _______________________________________ 2 reserves the right to modify the design Contents and appearance of products without prior Before using a new machine _______________________ 3 notice. Contents ______________________________________ 3 Safety instructions IMPORTANT! Personal safety equipment _________________________ 4...
Safety instructions Personal safety equipment The machine‘s safety equipment This section describes the machine‘s safety equipment, its function and how checks and maintenance are carried out to IMPORTANT INFORMATION ensure that it operates correctly. (See the chapter “What is • Incorrect or careless use of this machine can what“...
Page 5
Safety instructions 4. Hand guard 6. Silencer The guard is fitted in front The silencer is designed to of the front handle (mod. give the lowest possible noise HT 2122 T and HT 2126 level and to direct the T) and has the purpose of engine‘s exhaust fumes away protecting the left hand from the operator.
Safety instructions 3. Vibration damp- Control, maintenance and service of ing system the machine's safety equipment • Check the vibration damping elements IMPORTANT INFORMATION regularly for material • All service and repairs to the machine require cracks and distortion. special training. •...
Safety instructions Checking the clippers 6. Blade and hand guard Check the clippers each time Check that the blade guard they are used for: is secure and not damaged. • Damage and wear to the Check that the left and right the teeth.
Safety instructions A. Start C. Storage • Never start the engine indoors. The toxic exhaust gases are • Store the machine and fuel so that any leakage or fumes hazardous to inhale. do not risk coming into contact with sparks or naked flames.
Safety instructions 2. Avoid usage in unfavourable weather conditions. For Basic working technique example, thick fog, heavy rain, strong winds or extreme • Always cut with the engine at full throttle. cold, etc. To work in bad weather conditions is tiring and •...
NOTE! Do not tighten the screw so tightly that the blade is clamped • If Jonsered two-stroke oil is not available you can se a high tight. See chapter "Maintenance" for information on blade quality two-stroke oil intended for air cooled engines.
Fuel handling – Start and stop Fuelling Fuel handling Start and stop WARNING! Cold engine The following precautions reduce the risk of fire: 1. Push the short-circuiting Do not smoke or place any source of switch (1) to "ON" heat in the vicinity of the fuel. (forwards).
Start and stop – Maintenance Stopping Air filter The engine is stopped by The air filter must be switching off the ignition. cleaned from dust and dirt Move the stop switch in order to avoid: backwards to the STOP • Carburettor malfunctions. position.
Maintenance Lubricate the spring with WARNING! thin motor oil. • The return spring is tensioned in the 1. Insert a new starter cord starter housing and can with negligent through the hole in the handling spring out and cause injury. starter and anchor it in •...
Maintenance Blades Cooling system The blades have been fitted To maintain as low an in the blade guide with four operating temperature as resp. five screws. These possible the engine is screws must be tightened so equipped with a cooling that the clearance is system.