Status Messages; 8: Maintenance; Daily Preventive Maintenance; Extended Maintenance - Panduit PDM Operation Manual

© Panduit Corp. 2013
7H: Status Messages
Status messages are displayed as the dispenser performs self-diagnoses. No action is required on the part of the
operator other than notifying the maintenance department of the status message.
STATUS 1 - Calibrate line pressure sensor
Panduit
Calibrate line pressure sensor
STATUS 2 - Calibrate back pressure sensor
Panduit
Calibrate back pressure sensor
STATUS 3 - Reset EEPROM
Reset EEPROM
STATUS 4 - Reset dispenser RAM
Reset dispenser RAM
STATUS 5 - Reset tool RAM
Reset tool RAM

8: MAINTENANCE

8A: Daily Preventive Maintenance
The following maintenance of the PAT1M/PAT1.5M System must be performed daily (as needed) to ensure optimum
performance and trouble-free operation of the system.
INTERVAL
No more than 180 cycles
No more than 2500 cycles (= ½ cable tie reel)
8B: Extended Maintenance
CAUTION: SAFETY GLASSES WITH SIDE SHIELDS MUST BE WORN AT ALL TIMES
DURING THE MAINTENANCE OR ADJUSTMENT OF THE PAT1M / PAT1.5M TOOLS.
CAUTION: ALWAYS DISCONNECT AIR SUPPLY FROM TOOL BEFORE DISASSEMBLY.
CAUTION: ELECTROSTATIC SENSITIVE DEVICE. DO NOT OPEN OR HANDLE EXCEPT AT
A STATIC FREE WORK STATION.
OPERATION MANUAL
Page: 27 of 39
MAINTENANCE PROCEDURE
Empty tool tip collector before full.
(Refer to the Tip Collector section on Page 18.)
Empty dispenser carrier strip scrap bin.
(Refer to the Reloading Procedure section on Page 13.)
PAT1M, PAT1.5M, PDM
ENGLISH