Panduit PDM Operation Manual page 19

© Panduit Corp. 2013
The "Escape" button can be pressed to go directly to Level 1 or 1B Operator Menus (Refer to the Cable Tie
Installation section on Pages 17-18). It is important to note that the tool will only cycle cable ties when the display
is returned to the Level 1 or 1B Operator Menus ("Load, Unload, Menu" Display).
2. Press the "MENU" button to bring up the Level 2 menu:
LEVEL 2 - Load and Counter Reset Menu ("Reset" Display)
Resets load and/or counter
Reset Ld
The "Reset Ld" button will return to the last menu level (Level 1) while also resetting the Load counter back to
"14". This allows the unit to be reloaded (To reload the dispenser, follow the Reloading Procedure on Page 13).
Pressing the "Reset Ct" button will zero the "resettable counter" on the Level 1 menu.
There is not a "MENU" button in this level (Level 2) since it is the last menu level for operator use. The following
procedure is for lead person or setup person only.
The "Exit" button will return to the last menu level (Level 1). If ONLY the "Exit" button is pressed, the load
counter and or the "resettable counter" will remain unchanged. See Step 1.
-------------------------------------------------------------------------------------------------------------------------------------------------
3. The display at Level 2 does not show a "Menu" selection at the third button. The Setup menu levels (Level 3 thru
Level 6) are not required except to set, or to adjust the unit, and are reached by the following sequence:
a. Verify that the Level 2 menu is on the display.
b. Press the second button from the right, two times, followed by pressing the button on the far left, one (1)
time.
LEVEL 3 - Total Counts Menu (Dispenser and Tool)
Shows total counts
Counters
IMPORTANT!! Please note that once you press the "Escape" or "Exit" button to return to menu Level 1,
1B, or 2, you must repeat the sequence (Steps 3.a. and 3.b.) to re-enter the higher menu
levels (Level 3 thru Level 6).
Press the "Counters" button to view the total count to date for the PDM Dispenser and the PAT1M or PAT1.5M
Tool. Pressing this button will bring up the following display:
PDM
PAT1M # XXXXXX
The number (XXXXXX) to the right of each component is the serial number of the particular component. The
number (X.X) to the right of "Rev" represents the revision level of the software for the system. The number
(XXXXXXX) to the right of "Cycles" represents the number of times the particular component has been cycled.
These total counts are not resettable. Press Button 4 to return to the last menu level (Level 3).
Press the "Escape" button to return directly to Level 1 or 1B (Operator Menus). See Step 1.
Press the "MENU" button to advance to the next menu level (Level 4). See Step 4.
Press the "Exit" button to return to the last menu level (Level 2). See Step 2.
OPERATION MANUAL
Reset Ct
Escape
LEVEL 3A
# XXXXXX Rev X.X
Exit
Menu Exit
Cycles: XXXXXXX
Cycles: XXXXXXX
Page: 14 of 39
PAT1M, PAT1.5M, PDM
ENGLISH