Operational Safety Practices - Panduit PDM Operation Manual

© Panduit Corp. 2013
ONLY OPERATE THE PAT2S/PAT3S SYSTEM IN A CLEAN, DRY,
INDOOR ENVIRONMENT.
DO NOT EXPOSE POWER TOOLS TO RAIN OR WET CONDITIONS.
Water entering a power tool will increase the risk of electric shock.
If operating a power tool outdoors, use an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
NOTE: The term "residual current device (RCD)" may be replaced by the term "ground fault circuit
interrupter (GFCI)" or "earth leakage circuit breaker (ELCB)".
3C: Operational Safety Practices
1. DO NOT insert fingers in between the jaws of the tool or the rotary receiver area of the dispenser.
2. DO NOT attempt to operate the tool with cover open and the safety mechanism disabled.
3. DO NOT attempt to operate the tool with the cover open; the system will not cycle.
4. DO NOT operate the tool with the rear jaw held open. Cable ties may be ejected from the tool at high
velocities.
5. DO NOT operate the tool near anyone's face.
6. DO NOT operate the tool without a wire bundle in the jaws.
7. DO NOT operate the tool with any object blocking the path of the cable tie around the jaws.
OPERATION MANUAL
WARNING
KEEP AWAY FROM LIVE CIRCUITS:
•
Operating personnel must not remove covers.
•
Replacement of components and internal adjustments must be made by qualified
maintenance personnel.
•
Disconnect power cable when replacing components.
•
Dangerous voltages may exist even with the power cable removed.
•
To avoid injuries, always disconnect power and discharge circuits by grounding before
touching circuitry.
•
Input connection to the product must remain accessible as a disconnect device.
•
DO NOT work on the product; connect or disconnect cables during periods of
lightning.
•
Provide wiring per national and local electrical codes.
Page: 5 of 39
PAT1M, PAT1.5M, PDM
ENGLISH