Travel System Mode - Safety 1st Grow and Go TR405 Manual

Stroller seat can be installed rear-facing or forward-facing.
Car seat MUST ALWAYS face the stroller seat when in travel system mode.
Child tray MUST ALWAYS be used in travel system mode.
1
Install the stroller seat
either rear-facing or
forward-facng to the
attachments on the
stroller frame. You will
hear each side"click"
when it is locked
into place.
5
click!
Install the car seat to the
attachments on the stroller
seat. You will hear each side
"click" when it is secure.

Travel System Mode

2
Fully recline the
stroller seat backrest.
For more information
about adjusting
the backrest,
see page 10.
6
Pull the car seat up either at
the carry handle or
handle hubs to check if it is
attached securely.
TR405 takes model IC348 and Onboard 35FLX
TR438 takes model IC354and Onboard 35FLX
TR462 takes model IC374 and Onboard 35FLX
3
Fold the canopy back.
Adjust the stroller seat to the
most upright position.
For more information about
stroller seat positions,
see page 11.
To remove carseat from stroller seat, see
page 6: Removing Car Seat from Stroller
Frame or Stroller Seat.
Infant car seat models you can use:
4
Attach the child tray.
For more information
about the child tray,
see page 14.
OR
Finished!
9