Attaching Trim Caps And Trim Ledge; Attaching The Handwheel - Craftsman 113.2472T0 Owner's Manual

ATTACHING TRIM CAPS & TRIM LEDGE
1. Locate the two (2) trim caps, the trim ledge, and
from loose parts bag six (6) screws 1/4 x 1/2.
2. Place the trim ledge against the bottom of the
base, then reach through the base and secure the
trim ledge with the two screws using a phillips
screwdriver.
TRIM LEDGE PHILLIPS SCREWDRIVER
3. Position the trim caps in place and hold as
illustrated.
4. Then reach through the base and secure the trim
cap with the two (2) screws using a phillips
screwdriver. Repeat procedure for other side.
TRIM CAP
ATTACHING THE HANDWHEEL
1. From loose parts bag find one (1) pan head screw
10-32 x 2 and one (1) hex nut. Install the hand-
wheel. Reach inside the base to the back side of
the bevel mechanism and put the nut in place.
Hotd the nut in place with a finger. _nstall the
screw through the center of the handwheel and
tighten with a phillips screwdriver.
2. Hold the handle and pull the red release button
with your finger to close the handle.
17