Setting Up To Cut - Lincoln Electric SPIRIT II 150 Technical Manual

Section 4: Operation with Manual Gas Console

Setting up to Cut

The following procedure uses the information from the cutting charts in Section 5 to
prepare the system to cut. Always verify the correct gases are connected to the proper
input gas connections on the MGC in case marking was previously performed.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Push the OFF Button on the MGC to disable
the system. On the main menu, move the
pointer to Setup. Press the select  button.
Press the select  button until Cutting is
displayed.
Move the pointer to Current.
Press the select  button to cycle through the
list until the required amperage (from the
cutting chart) is displayed.
Move the pointer to Select Gas.
Press the select  button.
Press the select  button until the proper
Plasma gas is displayed. Move the pointer and
select the proper Shield gas. Move the pointer
to Return and press the select  button.
Move the pointer to Adjust Gas.
Press the select  button.
Move the pointer to a gas and then press the
select  button to start the flow that gas. Turn
the corresponding regulator knob on the MGC
to adjust the displayed pressure to match the
value in the cutting chart. Repeat for all other
gases. Move the pointer to Return and press
the select  button. Repeat to return to the
main menu. The system is now ready to cut.
4-2
Spirit II User's Manual