Sony KLV-19T400A Service Manual page 55

AV Set-up
Timer Settings
Power Saving
Product Information
Factory Settings
Video Labels
Assigns a name to any equipment connected to the side (refer A in page 18) and rear
jacks. The name will be displayed briefly on the screen when the equipment is
selected. You can skip input signals from connected equipment that you do not want
displayed on the screen.
F f
1 Press / to select the desired input source, then press
F f
2 Press / to select the desired option below, then press
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
"Edit:": Creates your own label. Follow steps 2 to 4 of "Programme Labels"
(page 29).
"Skip": Skips an unnecessary input source.
Speaker
Turns on/off the TV's internal speakers.
"TV Speaker": The TV speakers are turned on in order to listen to the TV's sound
through the TV speakers.
"Audio System": The TV speakers are turned off in order to listen to the TV's sound
only through your external audio equipment connected to the audio output jacks.
• All items in "Sound" menu except "Dual Sound" are not available when "Speaker"
is set to "Audio System".
Colour System
Selects the colour system ("Auto", "PAL", "SECAM", "NTSC3.58", "NTSC4.43"
or "PAL60") according to the composite video signal from the input source.
Sets the timer to turn on/off the TV.
Sleep Timer
Sets a period of time after which the TV automatically switches itself into standby
mode.
When the "Sleep Timer" is activated, the
lights up in amber.
z • If you turn off the TV and turn it on again, "Sleep Timer" is reset to "Off".
• A notification message appears on the screen one minute before the TV switches
to standby mode.
Wake Up Timer
Sets the desired period of time to turn on the TV from standby mode.
"Time": Sets the desired period of time to turn on the TV.
"Duration": Selects the time period after which the TV automatically switches to
standby mode again.
z • A notification message "TV has been turned on by Wake Up Timer" appears on
the screen when the TV is turned on using the wake up timer.
Selects the power saving mode to reduce the power consumption of the TV.
Choose either "Standard Power" or "Reduced Power".
Displays your TV's product information.
Resets all settings to factory settings other than "Programme Block", programme
preset data and the FM Radio preset data. After completing this process, the initial
set-up screen is displayed the next time you turn on the TV. Completing auto tuning
in initial set-up will reset these settings (except the FM Radio preset data). To keep
them, select "Cancel" in the auto tuning confirmation dialogue.
• Be sure not to turn the TV off during this period (it takes about 30 seconds) or press
any buttons.
.
.
(Timer) indicator on the TV front panel
27
GB