Sony KLV-19T400A Service Manual page 106

2
Secure the Mounting Hook from the left side
of the rear of the TV.
1 Secure the Mounting Hook to the rear of the TV
temporarily, using the supplied two screws (+PSW4 ×
12).
2 Be sure that both screws are tightened securely with
equal torque strength to the rear of the TV.
B
For KLV-26S400A/KLV-26T400A/KLV-26T400G/
KLV-19T400A/KLV-19T400G
GB
B
For KLV-19T400W
Notes
•
If you install the right Mounting Hook first, it will be
difficult to adjust its angle. Install the left Mounting
Hook first.
•
Be sure not to use any screws other than the supplied
ones (+PSW4 × 12) when securing the Mounting
Hook.
4
(GB)
Screw
(+PSW4 × 12)
Mounting Hook
Soft cloth
Screw
(+PSW4 × 12)
Mounting Hook
Soft cloth
3
Adjust the angle of the Mounting Hook.
When installing the TV parallel to the wall (0 degrees),
adjustment of the Mounting Hook angle (procedures
1 and 2 below) is not necessary.
1 Remove the angle adjusting screw from the arm of the
Mounting Hook. Choose the holes corresponding to
the desired angle (5, 10, 15 or 20 degrees).
2 Firmly secure the arm using the screw removed in the
previous procedure 1.
B
For KLV-26S400A/KLV-26T400A/KLV-26T400G/
KLV-19T400A/KLV-19T400G
Mounting Hook
Arm
Arm
1
2