Advertisement
ST-2510
VIBRATION-DAMPED BUCKING BAR
PARTS LIST
No.
10
11
11
12
13
Parts No.
1
1
2510-01
2510-01
2
2510-02
3
2510-03
4
2510-04
5
2510-05
6
6
2510-06
2510-06
7
2510-07
8
2510-08
9
2510-09
2510-10
2510-11
2510-11
2510-12
2510-13
Description
Dolly
Dolly
Bearing Strip (5x1.5x80)
Spring Pin (Φ4mmx25)
Front Part
O-Ring (25.1x1.6)
Front Piston
Front Piston
O-Ring (12.29x3.53)
Rear Pstion
Bearing Strip (5x1.5x120)
O-Ring (36x1.6)
Spring
Spring
Cylinder
Protective Cover
Q'ty
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
ST-2510-P-1809A-FY
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sumake ST-2510
Summary of Contents for Sumake ST-2510
- Page 1 ST-2510 VIBRATION-DAMPED BUCKING BAR PARTS LIST Parts No. Description Q'ty 2510-01 2510-01 Dolly Dolly 2510-02 Bearing Strip (5x1.5x80) 2510-03 Spring Pin (Φ4mmx25) 2510-04 Front Part 2510-05 O-Ring (25.1x1.6) 2510-06 2510-06 Front Piston Front Piston 2510-07 O-Ring (12.29x3.53) 2510-08 Rear Pstion 2510-09 Bearing Strip (5x1.5x120)
- Page 2 SUMAKE is a manufacturer and exporter of air SUMAKE is a manufacturer and exporter of air SUMAKE is a manufacturer and exporter of air...
- Page 3 HAMMER Original instructions SUMAKE Industrial Co. Ltd.
-
Page 4: General Safety Rules
The tool has been manufactured in conformity with the instruction of EU machine directive. The EU mark will be considered void in the event of inexpert repairs, the use of non-original parts and in case of non-observance of the safety instructions in the user’s manual. Possible direct or indirect consequential damages are not the responsibility of SUMAKE Industrial co., Ltd. General safety rules: Watch the tool at all times when in use. - Page 5 avoiding awkward off-balanced postures. The operator should change posture during extended tasks, which can help avoid discomfort and fatigue. 3. If the operator experiences symptoms, such as persistent or recurring discomfort, pain, throbbing, aching, tingling, numbness, burning sensations or stiffness, these warning signs should not be ignored. The operator should tell the employer and consult a qualified health professional.
-
Page 6: Specific Safety Instructions
7. Whenever universal twist couplings (claw couplings) are used, lock pins shall be installed and whipcheck safety cables shall be used to safeguard against possible hose-to-tool and hose-and-hose connection failure. 8. Do not exceed the maximum air pressure stated on the tool. 9.
Need help?
Do you have a question about the ST-2510 and is the answer not in the manual?
Questions and answers