U.k. Wiring Instructions - Princess 182103 Instructions For Use Manual

- Never move the appliance during use. The oil becomes hot and you can burn yourself. Wait until the oil has
cooled down before moving the fryer.
- Never immerse the appliance in water!
- Do not leave the appliance unattended while in use. Close supervision is necessary when the fryer is used
near children.
- Do not use the appliance if the cord is damaged. Send it to our service department to minimise any risk. With
this type of appliance, a damaged cord should only be replaced by our service department using special tools.
- Make sure the thin pipes running along the heating element are not damaged (do not dent or bend).
- The electrical part comes complete with a safety switch which ensures that the heating element can only
operate when the element is correctly positioned in the pan.
- Never use previously defrosted and subsequently refrozen products. These contain a lot of water which will
cause excessive spattering.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability, or
lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give
explicit instructions or supervise the use of the appliance.
In the case of overheating, the pan will switch off auto-mati-
cally. This safety mechanism can be found on the bottom of
the electrical part. If its switches off, it can be reactivated by
pressing in the button with a long pointed object. The button
is situated deep behind the hole and you should use the res-
tart pin supplied. First remove the plug from the socket.

U.K. WIRING INSTRUCTIONS

The wires in the mains lead are coloured in accordance with
the following code:
BLUE
BROWN
GREEN/YELLOW
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with the let-
ter E or and is coloured GREEN or GREEN/YELLOW
WARNING: THIS APPLIANCE MUST BE EARTHED
NEUTRAL
LIVE
EARTH
8