Table of Contents
Advertisement
To connect the host PC to the console port, a RJ45 (male) connector-to-RS232 DB9
(female) connector cable is required. The RJ45 connector of the cable is connected to the
CID port of VX-IGP-1204F; the DB9 connector of the cable is connected to the PC COM
port. The pin assignment of the console cable is shown below:
Connect & Login to Managed Switch
1.
Connecting to the Ethernet port (RJ45 Ethernet port) of Managed Switch.
2.
Factory default IP: 192.0.2.1
Login with default account and password.
3.
Username: admin
Password: (none)
CLI Initialization & Configuration (Optional)
1.
Connecting to the Ethernet port(RJ45 Ethernet port) of Managed Switch
2.
Key-in the command under Telnet: telnet 192.0.2.1
3.
Login with default account and password.
Username: admin
Password: (none)
4.
Change the IP with commands listed below:
CLI Command:
enable
configure terminal
interface vlan 1
ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
exit
Quick Installation Guide
Advertisement
Table of Contents
