Side-By-Side Installation Instructions; Wine Rack Removal/Installation - U-Line Echelon Series Installation Manual

Side-By-Side Installation
Instructions
For a complete refreshment center, install your 2175BEVS
or 2175BEVOL unit beside a U-Line Refrigerator, Ice Maker
or Combo Model (see Figure 4 for typical cut-out). Note
that each Side-By-Side Installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit's Installation Guide.
For example:
Placing a 2175 Beverage Center next to a 2115 series
unit would require a cut-out width of:
24-3/16" + 15-3/16" = 39-3/8"
Placing a 2175 Beverage Center next to a 2175 series
unit would require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit's
Electrical Specifications.
Typical Side-By-Side Cut-Out
34-1/4"
to
35-1/8"
1/4" Space
Between
Appliances
Figure 4
www.U-LineService.com
2175BEVS/2175BEVOL Beverage Center
23-1/4"
7"
1-1/2"
4 Prepare Racks and Door Frame
The U-Line Beverage Center is equipped with wood-
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor or
overlay frame. The trim on the racks may be coated with a
final finish or stained.
2175BEVOL Models are designed for, and require
installation of, an Overlay Frame.
If none of these treatments are to be included in this
installation, go on to 5 Adjust Door.
To prevent permanent damage to the inner liner of the
Beverage Center, the wine rack wood trim MUST be
removed from the unit for staining and/or finishing.
Allow stain/finish to dry thoroughly (at least 24 hours per
coat) in accordance with the stain/finish manufacturer's
instructions prior to re-installing the wood trim inside the
cabinet of the Beverage Center. Failure to do so may cause
the inner liner of the unit to have a permanent odor,
which is not covered by the warranty.

Wine Rack Removal/Installation

To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
Figure 5
3. Press the left rack release lever (Figure 5) down, and at
the same time, lift the corresponding right rack release
lever up, and pull the rack out until it is free of the
tracks and the cabinet.
IMPORTANT
Do not remove the track side rails from the cabinet.
6
CAUTION
ULIN_0162_A
01/2007