Table of Contents
Advertisement
SERVICE WORK ON THE CHASSIS 12
–
Shift the transmission into neutral.
–
Pull on the lower chain section with the specified weight
Guideline
Weight, chain wear mea-
surement
–
Measure distance
section.
Info
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Maximum distance
20 chain rollers at the
longest chain section
»
If distance
–
Change the drivetrain kit.
401288-10
–
Check the chain sliding guard for wear.
»
C
If in area
ble from above:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the screw of the chain sliding guard.
Guideline
F02825-10
Screw, chain slid-
ing guard
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 51)
15 kg (33 lb.)
B
of 20 chain rollers in the lower chain
304.0 mm (11.968 in)
B
from
B
is greater than the specified measurement:
Info
When a new chain is mounted, the rear
sprocket and engine sprocket should also be
changed.
New chains wear out faster on old, worn
sprockets.
by the chain sliding guard screw
M6
A
.
1
is visi-
9 Nm (6.6 lbf ft)
67
Advertisement
Table of Contents
