Before Calling For Service - Hoshizaki KM-130C Instruction Manual

ENGLISH
Wear protective equipment (e.g. protective glasses) when using the citric acid or sodium hypochlorite solution. The solution may
spout out and splash into your eyes. In that case, wash your eyes with clean water.
If the citric acid solution is found dripping on the sheet metal parts, wipe it off thoroughly to prevent rust.
1) Make either of the following solutions to fit the intended purpose.
Cleaning (descaling):
Sanitising:
2) Open the door, and remove all ice from the storage bin. Check that the
separator is attached in its correct position as shown. Otherwise, the
solution may splash onto the ice in the storage bin.
3) Press and hold the cleaning button for 3 seconds. The display flashes
the current mode. For example, the display showing "run" during the
icemaking operation starts to flash "run".
4) When the display changes to "cln", pour the following amount of solution
into the water tank carefully not to overflow it.
KM-40C: 2.0 litres
KM-60C: 2.5 litres
KM-80C: 3.0 litres
KM-130C: 3.5 litres
5) Rinse the bin liner with clean water to remove any solution spilled in the storage bin. Then, close the door.
6) Press the cleaning button (or wait for 15 minutes) to start the automated chemical cleaning.
7) The unit resumes the original state when the cleaning is over.
If the ice made after the automated chemical cleaning tastes wrong, immediately stop using the icemaker and call for service.
Fully Automated Chemical Cleaning (*)
* Available only for the fully automated cleaning model (-W) or when the fully automated cleaning kit (option) is used.
The fully automated cleaning kit automatically feeds a chemical (1250 ml of 40% citric acid solution) and descales the water
circuit at a desired frequency. Make necessary settings according to "II. 2. USER SETTINGS".
For further details, see the instruction manual of the fully automated cleaning kit ACK.

2. BEFORE CALLING FOR SERVICE

If the icemaker does not work properly or does not work at all, before calling for service, check that:
* The power is supplied to the unit.
* The water is turned on.
* The air filter is clean.
If the problem still exists, turn off the power supply, turn it back on, and press the reset button.
If the problem persists, check whether the error code "E" is indicated on the display or the dot at the center is on, and contact
your local Hoshizaki service agent.
If one of the following notice codes appears, follow the instructions below.
3.5 litres of 2% citric acid solution
3.5 litres of water mixed with 13 ml of 5.25% sodium hypochlorite solution
Do not damage the refrigerant circuit.
CAUTION
NOTICE
Separator
Water Tank
WARNING
WARNING
10