Table of Contents
Advertisement
<When using the Paper Feed Cabinet PC-410/PC-
210/PC-110>
a) Remove the rear right cover from the paper
feed cabinet. (Two screws)
b) Remove the knockout from the rear right cover
using nippers.
c) Route the network cable through the harness
guide and three wire saddles.
Note:
Leave an appropriate amount of slack in the por-
tion of the cable between the plug and the harness
guide in a manner which does not interfere with
the opening and closing of the cover.
Leave an appropriate amount of slack.
d) Route the cable through the notch and attach
the rear right cover. (Two screws)
19. Network setting
Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
(1) Select the function to be used as follows:
Menu → Utility → Administrator Settings → Enter
the Administrator Password → Network Settings
→ TCP/IP Settings → IPv4 Settings.
(2) Touch "Manual Input" of IP Address Setting
Method and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
(3) Touch "OK."
(4) Touch "OK" after the "TCP/IP Settings" screen is
displayed.
(5) Select the function to be used as follows:
Forward → Detail Settings → PING Confirma-
tion, and make the operation check of TCP/IP.
20. Restarting the machine
(1) Open the front door and turn OFF the power
switch.
(2) Turn ON the power switch again after 10 or more
seconds have passed, then close the front door.
E-11
Advertisement
Table of Contents
