Table of Contents
Advertisement
1.4.1.1.
Enabling the interface's video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface's video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.
1.4.1.2.
Vehicle specific settings (Dip 4)
Set Dip switch 4 to ON for Audi TT vehicles. For all other vehicles it has to be set to OFF.
1.4.1.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory LVDS picture while the reverse gear is engaged
to display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.1.4.
Monitor selection (Dip 6-8)
Dips 6-8 customize the monitor-specific video settings which sometimes even vary within
head units of the same version, caused by different monitor specifications. It is necessary to
try all possible combinations while a working video source is connected to the chosen input
of the interface. One of the six combinations will show the best picture size and quality
(some may give no picture). It is possible to first hot plug through the dip combinations. If
there is no change of picture visible after trying all 6 options, retry and disconnect the 10pin
plug of the Quadlock connector between every change of the dip setting.
Empirical value:
Vehicle
VW Golf7
Audi A3 (8V)
Audi A4 (8W), A5 (8T)
Audi A6/A7 (4G)
Audi Q7 (4M) Touch
Audi Q7 (4M) MMI
Porsche
VW Touran
Audi TT (8S)
Version 17.11.2017
All manuals and user guides at all-guides.com
Monitor
5.8"
5.8"
8.3"
8.3"
HW:CAM(V82)GD
Dip 4
Dip 6
8"
OFF
OFF
OFF
OFF
7"
OFF
OFF
OFF
OFF
OFF
ON
7"
OFF
OFF
8"
OFF
OFF
OFF
ON
7"
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
Dip 7
Dip 8
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
RL3-MIB-4
Advertisement
Table of Contents
