Table of Contents
Advertisement
3
Application and Deployment
3.8
Pole Mounting Options
3.8.1
Important Pole Mounting Safety Instructions
3.8.2
Pole Mounting Instructions
•
Always check the stand or pole specification to verify that it is
designed to support the weight of the CDL loudspeaker(s).
•
Always observe all safety precautions specified by any 3rd party
manufacturer of devices used with the CDL loudspeakers.
•
Always verify that the stand or subwoofer and subwoofer
pole is resting on a level, flat, and stable surface.
•
Tripod legs should be fully extended for maximum stability and positioned
in a low-traffic area so that the legs do not create a tripping hazard.
•
Route cables so that no one will trip over them as this could topple
the speaker and cause serious injury, damage, or death.
•
Stands, poles, and associated hardware should be inspected prior to each
use. Do not use equipment with worn, damaged, or missing parts.
•
For some applications, it may be necessary to place additional weights,
such as sandbags, on the base of the stand to for maximum stability.
•
Do not attach banners to the stand as these could function like a sail
to topple the system, causing serious injury, damage or death.
1. Select the pole socket angle for your application (0˚ or 7.5˚).
Note: When mounting (2) CDL loudspeakers, the 7.5˚ tilt mount must be utilized.
2. Carefully place one CDL loudspeaker on the loudspeaker pole
by inserting the pole completely into the pole socket.
3. If mounting (2) CDL loudspeakers on one pole, place the lower loudspeaker on
the pole first, then rig the top one to it following the instructions in Section 3.7.1.
Important: Use proper lifting techniques to avoid injury.
It is highly recommended that you team lift CDL loudspeakers
onto their pole mount for maximum safety and to avoid injury.
The following pole mounting options are supported:
•
(1) CDL loudspeaker on Tripod Stand
•
(2) CDL loudspeaker on Tripod Stand
WARNING The (2) CDL loudspeakers must be rigged to one another.
See Section 3.7.1 for instructions.
•
(1) CDL loudspeaker atop either (1) CDL Sub18,
(1) CDL18s, (1) ULT18, or (1) AIR18s
WARNING Maximum pole height from the top of the CDL Sub18 or
CDL18s to the bottom of the CDL loudspeaker cannot exceed
40". PreSonus recommends the K&M 21339.000.55 Crank Stand.
•
(1) CDL loudspeaker atop (2) CDL18s
WARNING Other stacked subwoofer configurations are not supported.
Maximum pole height from the top of the upper CDL Sub18
or CDL18s to the bottom of the CDL loudspeaker array cannot exceed
17". PreSonus recommends the K&M 21334.050.55 Distance Rod.
The (2) subwoofers must be rigged to one another.
See CDL Sub18 Owners Manual for instructions.
•
(2) CDL loudspeakers atop (1) CDL Sub18 or CDL18s
WARNING PreSonus only supported pole mounting (2) rigged
CDL loudspeakers atop a PreSonus CDL Sub18 or CDL18s subwoofer. No
other subwoofers are supported for this application. The maximum pole height
from the top of the CDL subwoofer to the bottom of the CDL loudspeaker cannot
exceed 33.5". PreSonus recommends the K&M 21339.000.55 Crank Stand.
The (2) CDL loudspeakers must be rigged to one
another. See Section 3.7.1 for instructions.
CDL12P / CDL 10P
Owner's Manual
11
Advertisement
Table of Contents
