Table of Contents
Advertisement
If you cannot view the live stream, you may see operation guidance
on the screen, or you can refer to Section 6 (Troubleshooting) for
further assistance.
MOUNT THE CAMERA ON THE WALL
4.3.
Head bolt
Bracket head
Screw
Before installing the camera, assess the effectiveness of your
installation and verify the camera's positioning by placing it against
the wall at the desired location. Position the camera at a distance of
more than 3ft from your baby's crib to ensure optimal viewing.
1) Securely hold the bracket against the wall. Then, use a marker
to indicate the locations of the three mounting holes.
2) Use a 1/5-inch (6mm) drill bit to create three holes at the
marked locations on the wall.
3) Insert the three anchors into the wall and gently tap them with a
hammer until they are flush with the surface of the wall.
4) Align the anchor holes on the wall, place the bracket, and insert
the three screws through the three holes of the bracket into the
anchors. Tighten the screws securely.
5) Locate the mounting hole on the bottom of the camera and
align it with the head of the bracket. Rotate the camera around
Figure 4: Wall Mount
Page 10 / Total 45
Bracket seat
Seat bolt
Anchor
Advertisement
Table of Contents
