Table of Contents
Advertisement
Figure 15. Remove the I/O board
Screw specifications
M2.0 x L3.0
Go to
https://support.lenovo.com/partslookup
part:
I/O board
Remove the memory module
Make sure the following FRU (or CRU) has been removed.
"Remove the deco cover" on page 30
"Remove the lower case" on page 31
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove the memory shielding.
Figure 16. Remove the memory shielding
Step 3.
Open the buckles and then remove the memory.
38
Hardware Maintenance Manual
Number of screws
1
to look up the Lenovo part number of the following replacement
Advertisement
Table of Contents
