Larson Electronics EXPCMR-IP-POE-4MP-IR-FLX.23-JB.3.SFC User Manual page 2

 INSTALLATION
• Choose a suitable location for mounting the camera. You will need to run RJ45
Ethernet cable to this location while maintaining area safety requirements. 3/8"-16 or
3/8"-24 bolts are recommended for mounting the camera with a minimum bolt length
of ¼" depending on the location.
• There are two 3/4" NPT hubs available for feeding wire to the camera. Power and data
is delivered via the same Ethernet cable using Power over Ethernet (PoE) technology.
This particular model is equipped with a 27.5'' flex coupler and 3 port juction box,
allowing the camera to be mounted to adjacent walls to the wiring conduit.
• Loosen the set screw and unscrew the lens of the enclosure. This will reveal the
cameras internals. Feed your supplied Ethernet cable through one end of the camera.
Find the female RJ45 keystone jack inside and attach the male end of your supplied
Ethernet cable. Once connected, test to ensure everything works via your NVR or
computer. Refer to page 22 for accessing the camera via a web browser.
Camera Defaults
• Once everything has been connected and tested, replace the camera and lens. Then,
tighten the set screw.
Explosion Proof Network IP Camera User Manual
IP Address: 192.168.1.64
Username: admin
Password: ChangeMeN0w
/
/
0 - Indicates a zero*
2