Troubleshooting - Fagor IO-WMS-1731 Instruction Manual

TROUBLESHOOTING

Problem
The washing machine is not working
Water Leakage
The load in the appliance has not been
spun
Unpleasant smell in the drum
No water in the drum
There is water left in the fabric softener
container.
Washing not properly rinsed
The appliance does not fill with water
Simultaneous water intake and draining.
Water does not drain properly
102
Probable cause/Solution
Open the water supply tap.
- clean the mesh filter on the supply hose
- close the door
- press the Start/ Pause button
- Properly connect the water supply hose.
- Replace the load evenly in the drum, clean the pump filter.
- Run the drum autoclean programme
- Open the water supply tap.
- Press down on the plastic tab located in the central compartment of
the detergent tank.
- Add correct amount of detergent, depending on the soiling level and
water hardness (see the instructions on the detergent packaging).
- Open the water valve,
- check programme settings,
- check water pressure,
- reconnect the water supply hose.
- close the door
- check that water intake hose is not bent or blocked
Check that the end of the drain hose is higher than the level of the
water in the appliance (the hose should be at a height of 0–100 cm).
- check the pump filter,
- check the drain hose,
- check the placement of the drain hose — is should be at a height of
0.6 to 1 m from the floor.