Installation/Removal; Installing The Brake Lever - Shimano DEORE Series Dealer's Manual

INSTALLATION/REMOVAL

Installing the brake lever

INSTALLATION/REMOVAL
Installing the brake lever
For the installation method when installing with an I-SPEC EV type shifting lever, refer to the
dealer's manual of the shifting lever being used.
When installing parts onto a carbon frame/handlebar, confirm the recommended tightening
torque with the carbon frame or handlebar manufacturer. This will prevent damage to the
frame/handlebar due to over-torquing or inadequate securing of the components.
1.
Open the clamp band of the brake lever.
(1) Loosen the mounting bolt.
(2) Press the recessed area of the clamp band with a tool such as a 2 mm hexagon wrench
to disengage the safety latch.
2.
Pull a snap spring to the clamp band side as shown in the figure.
(1)
(2)
Mounting bolt
Snap spring
12
Mounting bolt