Stihl RMI 632 C Instruction Manual page 186

– Replace the battery – observe
corresponding recommendation on the
display ( ), ( 24.)
– Switch on offset drive home (passage)
( 11.13)
Fault:
Unmown grass at edge of mowing area
Possible cause:
– Edge mowing switched off
– Perimeter wire routed inaccurately
– Grass is out of reach of mowing blade
Remedy:
– Mow the edge once or twice per week
( 11.13)
– Check routing of the perimeter wire
( 11.13), check clearances using the
iMOW® Ruler ( 12.5)
– Cut the unmown areas regularly using a
suitable grass trimmer
Fault:
No wire signal
Possible cause:
– Docking station switched off – no LED
illuminates
– Docking station not connected to mains
supply – no LED illuminates
– Perimeter wire not connected to the
docking station – red LED flashes
( 13.1)
– Break in perimeter wire – red LED
flashes ( 13.1)
– Robotic mower and docking station are
not linked
– Electronics fault– LED flashes SOS
( 13.1)
Remedy:
– Switch on the docking station (
– Check power supply to the docking
station ( 9.8)
184
– Connect the perimeter wire to the
docking station (
– Find the wire break (
repair perimeter wire using wire
connectors (
– Link robotic mower and docking station
( 11.15)
– Contact your specialist dealer ( )
Fault:
LED on the docking station flashes SOS
Possible cause:
– Minimum perimeter wire length not
reached
– Electronics fault
Remedy:
– Install the accessory (AKM 100) ( )
– Contact your specialist dealer ( )
Fault:
The robotic mower is not receiving any
GPS signal
Possible cause:
– Connection to satellites is currently
being established
– 3 or fewer satellites within range
– Machine is in a dead spot
Remedy:
– No further action required; it can take a
few minutes for connection to be
established
– Avoid or remove obstacles that might
be blocking signal (e.g. trees, canopies)
Fault:
The robotic mower cannot establish a
mobile radio connection
13.1)
Possible cause:
– Mowing area is in a dead spot
9.11)
16.7), then
12.16)
– Radio module is not activated
Remedy:
– Have the radio module activated by a
STIHL specialist dealer ( )
Fault:
The robotic mower cannot be reached
using the app
Possible cause:
– Radio module inactive
– Robotic mower is in standby mode
– No Internet connection
– Robotic mower is not associated with
correct e-mail address
Remedy:
– The radio module is switched off during
linking, then it is reactivated and the
robotic mower can be reached again
– Activate robotic mower by pressing
button, set "Standard" energy mode
( 11.10)
– Connect machine on which app is
installed to Internet
– Correct e-mail address (
0478 131 9954 E - EN
10.)