Stihl RMI 632 C Instruction Manual page 179

Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
– Robotic mower is located outside
mowing area
Remedy:
– Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
– The robotic mower has been lifted by
carrying handle
Remedy:
– Confirm the message with OK
Message:
1170 – No signal
Switch on docking station
Possible cause:
– Docking station is switched off
– No reception of wire signal during
operation
– Robotic mower is located outside
mowing area
0478 131 9954 E - EN
– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to docking station
– Check LED on docking station – the red
LED must be permanently illuminated
during operation ( 13.1)
– Return robotic mower to mowing area
– Link robotic mower and docking station
( 11.15)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
installed incorrectly
Remedy:
– Check LED on the docking station,
switch on the docking station if
necessary ( 13.1)
– Check docking ( 15.7)
– Check funnel-shaped entrance and exit
areas of the corridor ( 12.11)
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
robotic mower
Remedy:
– Dock robotic mower once docking
station is unoccupied again
Message:
1200 – Mowing motor fault
Mowing motor start not possible after 5
attempts
Possible cause:
– Dirt between carrier plate and mowing
deck housing
– Mowing motor cannot be switched on
– Mowing motor overloaded
Remedy:
– Clean mowing blade and mowing deck
( 16.2)
Clean carrier plate ( 16.6)
– Set higher cutting height (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
– Overload at a drive wheel
Remedy:
– Clean robotic mower ( 16.2)
– Level out any uneven areas (holes,
depressions) in mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required ( 11.11)
9.5)
177