Stihl RMI 632 C Instruction Manual page 130

Avoid routing at acute angles (less than
90°). In acutely angled lawn corners,
fasten the perimeter wire (1) to the ground
with fixing pins (2) as illustrated.
After a 90° corner, at least the length of an
iMOW® Ruler must be routed in a straight
line before the next corner is installed.
When routing around high obstacles such
as wall corners or high flowerbeds (1), the
wire clearance must be maintained at the
corners to prevent the robotic mower from
scraping against the obstacle. Route the
perimeter wire (2) with the aid of the
iMOW® Ruler (3) as illustrated.
● If necessary, extend the perimeter wire
using the wire connectors supplied.
( 12.16)
● In the case of several adjacent mowing
areas, install secondary areas
( 12.10) or join the mowing areas with
corridors. ( 12.8)
128
Last fixing pin with internal docking
station:
Drive in the last fixing pin (1) on the left or
right next to the floor plate, directly next to
the wire outlet. Cut off the perimeter
wire (2) to a free length of approx. 1.5 m.
Last fixing pin with external docking
station:
Drive in the last fixing pin (1) on the left or
right behind the floor plate, directly next to
the wire outlet. Cut off the perimeter
wire (2) to a free length of approx. 2 m.
Completing wire routing:
● Check the fastening of the perimeter
wire to the ground. One fixing pin per
metre is sufficient as a rough guide. The
perimeter wire must always lie on the
lawn. Drive the fixing pins fully into the
ground.
● After completing this installation
work, press the OK button on the
control panel.
If the battery is not sufficiently
charged to work through the
remaining steps of the installation
assistant, an appropriate message
is displayed. In this case, leave the
robotic mower in the docking
station and continue charging the
battery.
Jumping to the next step of the
installation assistant with the OK
button is only possible once the
necessary battery voltage is
available.
0478 131 9954 E - EN