Stihl RMI 632 C Instruction Manual page 184

– Rectify the displayed fault and confirm
the message with OK (
– End Homecall or call up the "Start"
menu again following docking
Fault:
The robotic mower is not working and
nothing is shown in the display
Possible cause:
– Machine is in standby
– Battery defective
Remedy:
– Press any button to wake up robotic
mower – status screen appears
( 11.2)
– Replace battery ( )
Fault:
The robotic mower is noisy and vibrates
Possible cause:
– Mowing blade is damaged
– Mowing deck is very dirty
Remedy:
– Replace mowing blade – remove any
obstacles from lawn (
– Clean mowing deck (
Fault:
Poor mulching or mowing result
Possible cause:
– Grass is too high in relation to cutting
height
– Lawn is extremely wet
– Mowing blade is blunt or worn
– Active times insufficient, mowing
duration too short
– Size of mowing area set incorrectly
– Mowing area with very high grass
182
– Long periods of rain
24.)
Remedy:
– Adjust cutting height (
– Adjust rain sensor (
Change active times (
– Replace mowing blade (
– Extend or add active times (
Extend mowing duration (
– Create new mowing plan (
– For neat mowing results, the robotic
mower needs up to 2 weeks, depending
on the size of the mowing area
– Allow mowing in rain (
Extend active times (
Fault:
Display in a foreign language
Possible cause:
– Language setting has been changed
Remedy:
– Set the language (
Fault:
Brown (earthy) patches appear in the
mowing area
16.4), ( )
16.2) Possible cause:
– Mowing duration is too long in relation
to the mowing area
– Perimeter wire has been routed with
excessively tight radii
– Size of mowing area set incorrectly
Remedy:
– Reduce the mowing duration (
– Correct the routing of the perimeter wire
(
– Create a new mowing plan (
9.5)
11.11)
11.7)
16.4), ( )
11.7)
11.7)
11.11)
11.7)
11.10)
12.)
Fault:
Mowing operations are significantly
shorter than usual
Possible cause:
– Grass is very high or too wet
11.7)
– Machine (mowing deck, drive wheels) is
very dirty
– Battery has reached end of service life
Remedy:
– Adjust the cutting height (
Set the rain sensor (
Change the active times (
– Clean the machine (
– Replace the battery – observe
corresponding recommendation in the
display ( ), (
Fault:
The robotic mower is docked, the battery is
not charging
Possible cause:
– Battery does not need to be charged
– Docking station not connected to power
supply
– Incorrect docking
– Charging contacts corroded
– Power supply unit defective
Remedy:
– No action necessary – battery charging
occurs automatically below a certain
voltage
– Check power supply to the docking
11.7)
station (
– Place the robotic mower in the mowing
area and send it back to the docking
11.7)
station (
docking – if necessary, correct the
position of the docking station (
– Replace the charging contacts ( )
9.5)
11.11)
11.7)
16.2)
24.)
9.8)
11.6), check for correct
9.1)
0478 131 9954 E - EN