Stihl RMI 632 C Instruction Manual page 178

Message:
0701 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery too low or too
high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (
Message:
0703 – Battery discharged
Battery voltage too low
Possible cause:
– Battery voltage too low
Remedy:
– Place robotic mower in docking station
to recharge battery ( 15.8)
Message:
0704 – Battery discharged
Battery voltage too low
Possible cause:
– Battery voltage too low
Remedy:
– Place robotic mower in docking station
to recharge battery ( 15.8)
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place robotic mower on its wheels,
check for damage and confirm
message with OK
176
Message:
1010 – iMOW® raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by hood
Remedy:
– Check movement of hood and confirm
message with OK
6.4)
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
– Control panel has been removed during
automatic operation
Remedy:
– Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
then press OK
Possible cause:
– Permanent collision detected
– Uneven areas around or underneath
docking station floor plate
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary – then confirm message with
OK
– Check movement of hood and confirm
message with OK
– Level out uneven areas and confirm
message with OK ( 9.1)
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler ( 12.5)
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
– Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (
0478 131 9954 E - EN
11.11)